The following is an overview of the user manual for the Z-Wave product Z-Wave Repeater (ZRP-110US)from Remotec. To view other Z-Wave products and manuals from Remotec follow that link.
Overview
ZRP-110 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
Security
As a Z-Wave Plus certified product, Z-Wave Repeater supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Remotec describes Z-Wave Repeater as having the following features:
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Repeater
1, Press and keep holding the PROG button for not less than 10 seconds. - LED state will toggle for first 5 seconds of being pressed.
LED state will toggle again after the remaining 5 seconds.
2, Release the PROG button then triple click the PROG button within 2 seconds of step 1.
- LED will stay in previous ON or OFF stage.
Remark: Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1, Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2, When prompted by your primary controller, triple click the PROG button within 1 second.
3, The primary controller should indicate that the action was successful. If the controller indicates the action was unsuccessful, please repeat the procedure.
1, Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2, When prompted by your primary controller, triple click the PROG button within 1 second.
3, The primary controller should indicate that the action was successful. If the controller indicates the action was unsuccessful, please repeat the procedure.
Please note that this is a user manual Z-Wave Repeater from Remotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Repeater and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.