The following is an overview of the user manual for the Z-Wave product Z-Wave Repeater (ZRP-120NA)from Remotec. To view other Z-Wave products and manuals from Remotec follow that link.
Overview
ZRP-120 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
Security
As a Z-Wave Plus certified product, Z-Wave Repeater supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Remotec describes Z-Wave Repeater as having the following features:
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Not support
Include or Exclude the ZRP-120 from the existing Z-Wave Home Control Network with your primary controller.
- Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
- When prompted by your primary controller, triple click the PROG button within 1 second.
- The primary controller should indicate that the action was successful. If the controller indicates the action was unsuccessful, please repeat the procedure.
Include or Exclude the ZRP-120 from the existing Z-Wave Home Control Network with your primary controller.
- Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
- When prompted by your primary controller, triple click the PROG button within 1 second.
- The primary controller should indicate that the action was successful. If the controller indicates the action was unsuccessful, please repeat the procedure.
Factory reset Z-Wave Repeater
All Configuration Parameter values and Association information will be restored to factory default settings and excluded from the network.
Step Setup Key LED Indication Status on ZRP-100
1 Press and keep holding the PROG button for not less than 10 seconds. - LED state will toggle for first 5 seconds of being pressed.
- LED state will toggle again after the remaining 5 seconds.
2 Release the PROG button then triple click the PROG button within 2 seconds of step 1. - LED will stay in previous ON or OFF stage.
Remark: All the setting and data will be permanently deleted. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Repeater from Remotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Repeater and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.