The following is an overview of the user manual for the Z-Wave product Z-Wave Slim Repeater (ZRP-200JP)from Remotec. To view other Z-Wave products and manuals from Remotec follow that link.
Overview
ZRP-200 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
Security
As a Z-Wave Plus certified product, Z-Wave Slim Repeater supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Remotec describes Z-Wave Slim Repeater as having the following features:
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1 Refer to your primary controller to enter into the Inclusion Mode or Exclusion Mode
2 When it is prompted to enter it, please triple click the “PROG” button within 1 second. Blue Indicator flashes TWICE then stay off
1 Refer to your primary controller to enter into the Inclusion Mode or Exclusion Mode
2 When it is prompted to enter it, please triple click the “PROG” button within 1 second. Blue Indicator flashes TWICE then stay off
Factory reset Z-Wave Slim Repeater
Press and Hold “PROG” button for 3 seconds on Z-Wave Slim Repeater, the indicator will light up Purple Color. DO NOT Release the “PROG” Button until indicator change back to Blue color and flashes TWICE.
Remark : All the Setting and Data will be permanently deleted.
*Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Slim Repeater from Remotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Slim Repeater and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.