Zrc-90us (BW8510US) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Zrc-90us (BW8510US)from Remotec. To view other Z-Wave products and manuals from Remotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
ZRC-90US
SKU Code
BW8510US
Description
The ZRC-90 Scene Master is a Z-Wave Central Scene Controller. When one of the buttons on the ZRC-90 is pushed, your Z-Wave central controller will receive a signal which it can use to trigger unlimited control possibilities. With 8 buttons, each supporting a long-press capability, you can control 16 different actions in your central controller. The ZRC-90 is a great solution for triggering events more quickly than taking out your smart-phone and running a home control app. The Scene Master is ideal for kids, elderlies and guests who may not have full access to your smart home’s mobile application and hence may not have the rights to switch on various lighting, heating, air conditioning and other home appliance. With a convenient snap-in wall mount, the ZRC-90 can also be removed to keep it handy while you go about your home for the ultimate in simple convenience.
Version #
03 was the version certified
Certification #
ZC10-15100007
Certified
2015-10-12T12:23:59.5166
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Zrc-90us supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Remotec describes Zrc-90us as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Click once on the “R” button to remove the device from ZRC-90 Z-Wave network.

    Press “L+R” buttons simultaneously until LED light up to add the device into ZRC-90 Z-Wave network.

    When prompted by your primary controller (gateway), click once on the “L” button.

    Enter to the Listening mode (Wake up) by click once on “W” button.

    Create a Primary Controller - Press “W+L” buttons simultaneously until LED light up.
    Create a Secondary Controller - Press “W+R” buttons simultaneously until LED light up.
    (Place the two controllers close to each other.)

    Factory reset Zrc-90us

    Press and keep holding “R” button not less than 10 seconds.
    Release “R” button then triple click on “R” button within 2 seconds.

    Please note that this is a user manual Zrc-90us from Remotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Zrc-90us and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.