The following is an overview of the user manual for the Z-Wave product HomeIQ Hub (H3PS-WC1)from Rent Café. To view other Z-Wave products and manuals from Rent Cafe follow that link.
Overview
Residents can control all the smart devices through the existing RENTCafé Resident App.
Security
As a Z-Wave Plus certified product, HomeIQ Hub supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Rent Cafe describes HomeIQ Hub as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Removing devices
1. Execute the “Network-Exclusion” command
2. Start exclusion mode procedure for the device to be removed
3. Upon successful completion a message indicating which node ID was removed is printed
Print Provisioning List
o SmartStart-Get can be used to see an individual entry
o SmartStart-GetAll can be used to see all SmartStart entries
Add to Provisioning List
o The SmartStart-Add command will prompt for the DSK of the device to be added
Remove from Provisioning List
o SmartStart-Delete can be used to remove an entry
Adding Non-S2 devices
1. Execute the “Network-Inclusion” command
2. Enter “N” on the “Pre-enter DSK?” prompt
3. Start add node procedure for the device to be added
4. Upon successful completion a message indicating which node ID was allocated to the included node is printed
Adding S2 devices
1. Execute “Network-Inclusion” command
2. Enter “N” on the “Pre-enter DSK?” prompt
3. Start add node procedure for the device to be added
4. If prompted, enter PIN (5 digits) to be included
3. Upon successful completion a message indicating which node ID was allocated to the included node is printed
SmartStart installation
Add to Provisioning List
o The SmartStart-Add command will prompt for the DSK of the device to be added
Not available
Not available
Factory reset HomeIQ Hub
Using the console application you can execute the “Network-Reset” command to factory reset the Z-Wave controller.
The “Node-Update” command will update the network status and device information of the provided node ID. If the node update does not fully rediscover the nodes capabilities it will have to be excluded and reincluded into the network.
SmartStart location
SmartStart QR code's location as follows: The Device Specific Key (DSK) for the controller is available through the console application using the “DSK-Get” command. The full DSK will be printed.
Please note that this is a user manual HomeIQ Hub from Rent Café is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have HomeIQ Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.