Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Dimmer (39458/ZW3010) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Dimmer (39458/ZW3010)from Resideo. To view other Z-Wave products and manuals from Resideo follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Dimmer
SKU Code
39458/ZW3010
Description
In-Wall Smart Dimmer with QuickFit and SimpleWire enhancements. Revolutionary QuickFit design features a housing depth that is up to 20 percent smaller than the previous Z-Wave models. This reduced size coupled with the elimination of heat taps provides a better fit in older style boxes and multi-gang configurations. SimpleWire technology allows line and load to automatically be configured with auto-sensing line-load terminals. All of this is coupled with Z-Wave S2 and Smart Start allows for effortless installation while being safer than ever!
Version #
HW: 255 FW: 5.54 was the version certified
Certification #
ZC10-19126826
Certified
2019-12-20T11:23:28.240131
Z-Wave Version
6.81.04

Security

As a Z-Wave Plus certified product, In-Wall Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Resideo describes In-Wall Smart Dimmer as having the following features:

  • Neutral Wire Required
  • Z-Wave Scene Type
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: This dimmer is SmartStart enabled. If your controller supports SmartStart inclusion, this dimmer can be added into the Z-Wave network by following the instructions for your controller or hub and scanning the Z-Wave QR Code on the front or on the package when instructed. No further action is required, and the dimmer will be added automatically within 10 minutes of being powered up while in range Z-Wave network.

Press on 2 times and off 2 times. LED will flash 5 times if exclusion was successful.

This dimmer is SmartStart enabled. If your controller supports SmartStart inclusion, this dimmer can be added into the Z-Wave network by following the instructions for your controller or hub and scanning the Z-Wave QR Code on the front or on the package when instructed. No further action is required, and the dimmer will be added automatically within 10 minutes of being powered up while in range Z-Wave network.

Factory reset In-Wall Smart Dimmer

Quickly press ON button 3 times then immediately press the Off button 3 times. The LED will flash ON/OFF 5 times when completed successfully.

Please note that this is a user manual In-Wall Smart Dimmer from Resideo is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.