The following is an overview of the user manual for the Z-Wave product Plug-in Outdoor Smart Switch (39453 / ZW4203)from Resideo. To view other Z-Wave products and manuals from Resideo follow that link.
Overview
Security
As a Z-Wave Plus certified product, Plug-in Outdoor Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Resideo describes Plug-in Outdoor Smart Switch as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: If prompted by the controller to enter the S2
security code, refer to the QR code/security number on
the side of the box or the QR code label on the product
(see Figure 1). Enter the 5-digit code.
ADDING YOUR DEVICE TO A Z-WAVE NETWORK
1. Follow the instructions for your Z-Wave certified
controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press
and release the manual/program button on the smart
switch to add it in the network.
3. The controller’s app will indicate if it has discovered the
switch. If prompted by the controller to enter the S2
security code, refer to the QR code/security number on
the side of the box or the QR code label on the product
(see Figure 1). Enter the 5-digit code.
TO REMOVE AND RESET THE DEVICE
1. Follow the instructions for your Z-Wave certified
controller to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press
and release the manual/program button on the smart
switch to remove it from the network.
Factory reset Plug-in Outdoor Smart Switch
TO RETURN YOUR SWITCH TO FACTORY DEFAULTS
1. If plugged in, unplug the device from the receptacle.
2. Press and hold the manual/program button, plug the
device in and continue to hold for at least 3 seconds.
NOTE: This should only be used in the event your network’s
primary controller is missing or otherwise inoperable.
Please note that this is a user manual Plug-in Outdoor Smart Switch from Resideo is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Outdoor Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.