The following is an overview of the user manual for the Z-Wave product Rocket Bulb (JZB01DIM)from RouteZ. To view other Z-Wave products and manuals from RouteZ follow that link.
Overview
2.Standard form factor and appearance of the light bulb
with 806 lm output
4.Possible to be included in groups, scenes, or schedules
5.Suitable for indoor lighting:
Corridors, Bedroom, Living Room, etc.
Security
As a Z-Wave Plus certified product, Rocket Bulb supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
RouteZ describes Rocket Bulb as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Remove for exclusion: Trigger OFF->ON->OFF->ON->OFF->ON
1. LED Bulb will light up with previously saved state and send node info frame.
2. Remove for exclusion:
a) Assuming led bulb was added to controller and was power on.
b) Set the Z-Wave network main controller into removing mode.
c) Power cycle triple for led bulb (OFF->ON->OFF->ON->OFF->ON).
d) Wait a moment, the led bulb should be removed from the controller.Then the led bulb will flash once and dim to 5%.
SmartStart Inclusion: Trigger OFF->ON
1. The LED light will flash twice.
2. Add for inclusion(SmartStart Inclusion):
Add the led bulb DSK into the primary controller Smart Start Provisioning List
(If your controller does not support SmartStart inclusion, please refer to the manual for your controller for non-SmartStart inclusion.)
a) Power cycle once for led bulb.
b) The led bulb will send “Explorer Auto inclusion” frame to start Smart Start Inclusion.
c) Wait a moment, the led bulb should be added to the controller.Then the led bulb will flash once when it has been included into the network.
Note: The led bulb will start SmartStart Inclusion when it is removed from a Z-Wave network.
Normal Inclusion: Trigger OFF->ON->OFF->ON-->OFF->ON
1. The LED light will flash twice, and send node info frame.
2. Add for inclusion(Normal Inclusion):
a) Set the Z-Wave network main controller into learning mode.
b) Power cycle once for led bulb.
c) Wait a moment, the led bulb should be added to the controller.Then the led bulb will flash once when it has been included into the network.
Factory reset Rocket Bulb
Reset the device :
Trigger:OFF->ON->
OFF->ON->OFF->ON->OFF->ON->OFF->ON->OFF->ON
Led bulb re-power 6 times (between 0.5-2 seconds each time); If the 6th power on, the led bulb flashes twice, which means that the resetting is successful. it will send “Device Reset Locally Command”.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Rocket Bulb from RouteZ is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Rocket Bulb and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.