The following is an overview of the user manual for the Z-Wave product The Doorlock (QLDLZW)from Safetech Products. To view other Z-Wave products and manuals from Safetech Products follow that link.
Overview
Security
As a Z-Wave Plus certified product, The Doorlock supports Z-Wave S2 security. The following security modes are directly supported:
Features
Safetech Products describes The Doorlock as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Prepare your Z-Wave controller to remove a device from the network (refer to your controller's user manual)
Push the Z-Wave button on The Doorlock. (See diagram in Product Manual for button placement.)
Prepare your Z-Wave controller to add a device to the network (refer to your controller's user manual.) Push the Z-Wave button on The Doorlock. The button is accessed through a small hole, insert a paperclip or similar to push it. (See diagram in Product Manual for button placement.)
Factory reset The Doorlock
To reset The Doorlock's Z-Wave settings to their factory defaults, hold the Z-Wave button down for 5 seconds. (See diagram in Product Manual for button placement.) The reset procedure should only be used when the primary controller is missing or inoperable.
Please note that this is a user manual The Doorlock from Safetech Products is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have The Doorlock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.