The following is an overview of the user manual for the Z-Wave product Curtain Motor Control with external module (SK-3007-05)from Saykey. To view other Z-Wave products and manuals from Saykey follow that link.
Overview
Security
As a Z-Wave Plus certified product, Curtain Motor Control with external module supports Z-Wave S2 security. The following security modes are directly supported:
Features
Saykey describes Curtain Motor Control with external module as having the following features:
- Window Covering Control Features
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Connect power supply to motor and connect the external module to motor external connector, and Make sure the module is located within direct range of the Z-Wave controller.
2. Set the controller into the inclusion/add mode (refer to controller’s operating manual).
3. Click the PB-button triple times in 1.5 second, located left side of the motor external box.
4. Curtain motor will be detected and included in the Z-Wave network.
1. Connect power supply to motor and connect the external module to motor external connector, and Make sure the module is located within direct range of the Z-Wave controller.
2. Set the controller into the exclusion/remove mode (refer to controller’s operating manual).
3. Click the PB-button triple times in 1.5 second, located left side of the motor external box.
4. Curtain motor will be detected and excluded from the Z-Wave network.
Factory reset Curtain Motor Control with external module
1. Connect power supply to motor and connect the external module to motor external connector.
2. Press and hold the PB-button excess 10 second.
3. Curtain motor will be reset to factory default and clear Z-Wave included network state.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Curtain Motor Control with external module from Saykey is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Curtain Motor Control with external module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.