The following is an overview of the user manual for the Z-Wave product PIR Detect Sensor (SK-3003-07)from Saykey. To view other Z-Wave products and manuals from Saykey follow that link.
Overview
false alarm rate.
Security
As a Z-Wave Plus certified product, PIR Detect Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Saykey describes PIR Detect Sensor as having the following features:
- Battery Quantity
- Battery powered using VR123 batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Make sure battery level is normally and the product is located within direct range of the Z‐Wave controller.
2) Set the main controller into the exclusion/Remove device mode (refer to main controller’s operating manual).
3) Click the Add/Remove button on the bottom side of product triple times in 1.5 seconds.
4) The product will be detected and excluded from the Z‐Wave network.
1) Make sure battery level is normally and the product is located within direct range of the Z‐Wave controller.
2) Set the main controller into the inclusion/Add device mode (refer to main controller’s operating manual).
3) Click the Add/Remove button on the left side of product triple times in 1.5 seconds.
4) The product will be detected and included in the Z‐Wave network.
Factory reset PIR Detect Sensor
The factory default settings are restored when the device is removed from the network or press and hold the Add/Remove button on
the left side of product excess 10 seconds.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
The Notification Reports cannot be deactivated. Application Rejected Request with status 0x00 occurs when the controller tries to
deactivate/turn off the Notification Type in order to not trigger the specific Notification Report again.
The product is in battery power, you can set up the wake up time based in seconds. At each wake up, the product communicates
with the master controller to updates parameters settings if necessary, e.g. receive the association group setting. The product will wake up at defined time interval and will ALWAYS try to communicate with the master controller. Longer time interval means less frequent communication and thus a longer battery life.
The product default wakeup interval is 86400 seconds. User can operate inclusion/exclusion process in order to trigger product
wakeup manually, it will keeps 30 seconds in wakeup state without initial wakeup parameter setting and keeps 10 seconds in
wakeup after initial wakeup parameter.
Please note that this is a user manual PIR Detect Sensor from Saykey is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR Detect Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.