The following is an overview of the user manual for the Z-Wave product J-Series by Z-Wave Keypad Lever (JFE109)from Schlage . To view other Z-Wave products and manuals from Schlage follow that link.
Overview
The lock comes preprogrammed with two access codes and can hold up to 30 unique codes for family members and trusted friends. The fingerprint-resistant touchscreen helps access codes stay private, minimizing tell-tale wear that can tip off possible intruders.
The J-Series by Schlage Z-Wave Deadbolt is battery-powered with a low battery warning that gives you weeks of advanced notice before it runs out. With guaranteed fit on standard doors, it’s easy for homeowners to install in minutes with just a screwdriver. The touchscreen continues to work in the event of a power outage, so you don’t have to worry about getting locked out – plus, a back-up key is included with the lock for peace of mind.
The J-Series by Schlage Z-Wave Lever incorporates Z-Wave Plus™ S2 technology, an enhanced security protocol that features an additional layer of AES encryption of wireless signals. The Z-Wave technology allows you to integrate your exterior door locks with other Z-Wave smart home devices, such as cameras, motion detectors, lights and thermostats, bringing the safety, simplicity and style of Schlage to your smart home.
Security
As a Z-Wave Plus certified product, J-Series by Z-Wave Keypad Lever supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Schlage describes J-Series by Z-Wave Keypad Lever as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: For enrollment in some Z-Wave Plus networks, an additional
5 digit code may be required to be entered into the home
automation system or panel during Step 4. Enter the 5
digit code shown on the label located on lock or on the
cover of the included installation instructions
Place your Z-Wave Controller into the "Add" (Inclusion Mode) or "Remove" (Exclusion Mode). Refer to the respective documentation for your home automation system for details. Remove the battery cover. Press and hold enrollment button under battery cover for 0.5 to 3 seconds as shown. Solid amber LED will be ON. Release the enrollment button. An LED will flash amber indicating the "Add" or "Remove" process is in progress. Success is indicated by a green LED blink and a beep.
Place your Z-Wave Controller into the "Add" (Inclusion Mode) or "Remove" (Exclusion Mode). Refer to the respective documentation for your home automation system for details. Remove the battery cover. Press and hold enrollment button under battery cover for 0.5 to 3 seconds as shown. Solid amber LED will be ON. Release the enrollment button. An LED will flash amber indicating the "Add" or "Remove" process is in progress. Success is indicated by a green LED blink and a beep.
Factory reset J-Series by Z-Wave Keypad Lever
Press and hold the enrollment button. The LED will light solid amber. After about 8 seconds of holding the button, the amber light will turn off. Release the button. Successful FDR is indicated by 3 long green blinks and 3 long beeps. You must enter a valid user code. Lock will enter auto-handling routine, locking and unlocking several times. Auto-handling is complete when lock movement stops.
N/A
N/A
Please note that this is a user manual J-Series by Z-Wave Keypad Lever from Schlage is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have J-Series by Z-Wave Keypad Lever and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.