The following is an overview of the user manual for the Z-Wave product Z-Wave Mortise Lock (S-6500F)from Schlage . To view other Z-Wave products and manuals from Schlage follow that link.
Overview
S-6500F lock must be used in conjunction with a Security Enabled Z-Wave Controller to fully utilize all implemented functions.
S-6500F lock supports the original Z-Wave Security Standard S0 and the new Security Standard S2 with SmartStart enabled and can be part of any Z-Wave network with other Certified Z-Wave or Z-Wave Plus products.
Security
As a Z-Wave Plus certified product, Z-Wave Mortise Lock supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Schlage describes Z-Wave Mortise Lock as having the following features:
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using AA batteries
- Door Lock Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The QR code will be printed on the plug-in Z-Wave module
1. Place your Z-Wave Controller into the “Remove” or Exclusion Mode (Refer the respective documentation for that specific home automation system or panel device for details).
2. Slide the battery cover upward.
3. Press the wireless button more than 3 seconds.
4. Press “2” on the keypad.
5. Press “6” on the keypad.
6. Press User Code on the keypad.
7. Press “#” on the keypad.
8. If RF LED flickers, exclusion has completed successfully.
9. If battery replace LED flickers, try repeating steps 1-7.
Factory reset Z-Wave Mortise Lock
Please use this procedure only when the network primary controller is missing or otherwise inoperable
When Master code was already registered
1. Remove batteries (power off).
2. Press “N” and “S” buttons at the same time and hold.
3. Insert batteries (power on).
4. Release “N” and “S” buttons.
5. Press 3-digit Master code.
6. Press “#” on the keypad.
7. Press “8” on the keypad.
When Master code was not registered yet
1. Remove batteries (power off).
2. Press “N” button and “S” button at the same time and hold.
3. Insert batteries (power on).
4. Release “N” and “S” buttons.
5. Press 3-digit Master code to register.
6. Press “#” on the keypad.
7. Press previous 3-digit Master code.
8. Press “#” on the keypad.
1. Place your Z-Wave Controller into the “Add” or Inclusion Mode (Refer the respective documentation for that specific home automation system or panel device for details).
2. Slide the battery cover upward.
3. Press the wireless button more than 3 seconds.
4. Press “1” on the keypad.
5. Press “6” on the keypad.
6. Press User Code on the keypad.
7. Press “#” on the keypad.
8. If RF LED flickers, inclusion has completed successfully.
9. If battery replace LED flickers(fail), try repeating steps 1-7.
Not Applicable. This Lock is FLiRS device.
N/A
Please note that this is a user manual Z-Wave Mortise Lock from Schlage is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Mortise Lock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.