The following is an overview of the user manual for the Z-Wave product Home Automation Gateway (HA102)from Schwaiger Home. To view other Z-Wave products and manuals from Schwaiger Home follow that link.
It is based on a cost-effective “proven” SoC with outstanding LAN/Wi-Fi capabilities and supports worldwide markets thanks to the external power supply.
Combined with Schwaiger client (Android/iOS/HTML) applications and Schwaiger cloud service it provides a turnkey platform that covers lighting, security, safety, energy management and other aspects of the fast-growing home automation markets.
As a Z-Wave Plus certified product, Home Automation Gateway supports Z-Wave S2 security. The following security modes are directly supported:
Schwaiger Home describes Home Automation Gateway as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Supported Meter Type
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
To enable DOC400 Gateway to receive information from another controller, start learn mode. To put controller into learn mode, from client application select Home setup, select gateway and from the drop down list select Add device. finally in option menu select Learn mode. Other way to initiate learn mode Short press BACK button twelve times. When controller enters learn mode it will lose all Z-Wave devices that were previously included. To include DOC400 Gateway to another controller network, start inclusion on the inclusion controller and start Learn mode on DOC400 gateway.
To open network for inclusion, from client application select Home setup, select gateway and from the drop down list select Add device. finally select Find devices. Other way to open network for inclusion is to press shortly 2x front button on the gateway.
To open network for exclusion, from client application select Home setup, select gateway and from the drop down list select Add device. finally in option menu select Exclude device. Other way to open network for exclusion is to press shortly 4x front button on the gateway.
Factory reset Home Automation Gateway
Reset user preferences - This function will permit to reset all user configuration settings. Short press on FRONT button six times will reset user preferences. During reset LED blink red two times per second.
Factory settings - The factory settings function will reset the gateway to the state in which it was delivered. Doing so will delete all of the saved data. Furthermore, all saved Z-Wave settings will be deleted as well as the scenarios already created. Short press on BACK button nine times gateway will reset on factory settings. During reset LED blink red one time per second.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Home Automation Gateway from Schwaiger Home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Home Automation Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.