The following is an overview of the user manual for the Z-Wave product Multifunction Switch (FMS)from SE Devices. To view other Z-Wave products and manuals from SE Devices follow that link.
Overview
Room and Floor temperature sensors can also be connected to the device, which enables the device to function as a head-less Thermostat. The Thermostat is fully controllable from a Z-Wave Controller, and can control both a Local and Remote heating relay.
Security
As a Z-Wave Plus certified product, Multifunction Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
SE Devices describes Multifunction Switch as having the following features:
- Color
- Thermostat Power Source
- Switch Type
- Z-Wave Scene Type
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Supported Meter Type
- Neutral Wire Required
- Sensors
- Thermostat Modes
- Thermostat HVAC Systems Supported
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Multifunction Switch
Push and Hold both Left buttons simultaneously for 15 seconds, until the Lower Left LED starts blinking. Push and Hold the Lower Right button to confirm Factory Reset. The procedure can be aborted at any time, and will also be aborted if any other button than the Lower Right is pushed after the initial 15 second push and hold.
WARNING! Executing a Factory Reset will set all configuration to factory defaults, and remove the device from the Z-Wave network. As all configuration is reset, the device may stop operating as intended and may require a re-configuration.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
The Multifunction Switch is capable of controlling local loads via a modular Back Unit. The back unit can be mounted and connected to mains electricity inside a Electrical Wall box. Two types of Relay and Dimmer Back Units are currently available. The maximum controllable local load are specified in each Back Unit product sheets.
Push and Hold both Lower buttons simultaneously for 5 seconds. Inclusion is indicated by the LEDs flashing in a ""U"" shaped pattern.
Push and Hold both Lower buttons simultaneously for 5 seconds. Exclusion is indicated by the LEDs flashing in a ""U"" shaped pattern.
Push and Hold both Lower buttons simultaneously for 5 seconds. Inclusion is indicated by the LEDs flashing in a ""U"" shaped pattern.
Push and Hold both Lower buttons simultaneously for 5 seconds. Exclusion is indicated by the LEDs flashing in a ""U"" shaped pattern.
Please note that this is a user manual Multifunction Switch from SE Devices is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multifunction Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.