The following is an overview of the user manual for the Z-Wave product Standalone 1-10V Dimmer (AD1-10V)from SE Devices. To view other Z-Wave products and manuals from SE Devices follow that link.
Overview
The device supports power measurement, reporting both instant and accumulated power consumption over time.
Security
As a Z-Wave Plus certified product, Standalone 1-10V Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
SE Devices describes Standalone 1-10V Dimmer as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Sensors
- Electric Load Type
- Supported Meter Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the device to a Z-Wave network, the Z-Wave Controller must first be set into Add (Learn) mode. Then use a paperclip or a small pointy tool to push and hold the button in the button hole for approximately a second. The device LED will blink twice to indicate that it sends information to the Controller.
To remove the device from a Z-Wave network, the Z-Wave Controller must first be set into Remove mode. Then use a paperclip or a small pointy tool to push and hold the button in the button hole for approximately a second. The device LED will blink twice to indicate that it sends information to the Controller.
Factory reset Standalone 1-10V Dimmer
WARNING! Executing a Factory Reset on a device may make it stop working as wanted, and will disable remote control of the device. The device will have to be re-added to the Z-Wave network and reconfigured afterwards, to regain the previous operation of the device. Please DO NOT execute this procedure unless it is absolutely necessary.
Push and Hold the Add/Remove button for about 15 seconds – until the LED indicator turns OFF. Then release the button. The device is now Factory Reset, and removed from the Z-Wave network.
The button is located about 10 mm down in the middle of the three holes on the front. A thin tool (a very small screwdriver, a toothpick, a paper clip or similar) is needed to access the button.
Please note that this is a user manual Standalone 1-10V Dimmer from SE Devices is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Standalone 1-10V Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.