The following is an overview of the user manual for the Z-Wave product Standalone Relay 2-Pole (AR2P)from SE Devices. To view other Z-Wave products and manuals from SE Devices follow that link.
Overview
The Relay can be used to switch both Heat Sources and Light fixtures. The product also contains a fail-safe mechanism which will switch the relay ON and OFF at fixed intervals, in case communication from a controlling device is lost.
The Relay measures the immediate and accumulated power consumption of an attached load, which is reported at fixed intervals.
Security
As a Z-Wave Plus certified product, Standalone Relay 2-Pole supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
SE Devices describes Standalone Relay 2-Pole as having the following features:
- Supported Meter Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Neutral Wire Required
- Sensors
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To remove the device from a Z-Wave network, the Z-Wave Controller must first be set into Remove (Learn) mode. Then use a paperclip or a small pointy tool to push and hold the button in the button hole for approximately a second. The device LED will blink twice to indicate that it sends information to the Controller.
To add the device to a Z-Wave network, the Z-Wave Controller must first be set into Add (Learn) mode. Then use a paperclip or a small pointy tool to push and hold the button in the button hole for approximately a second. The device LED will blink twice to indicate that it sends information to the Controller.
Factory reset Standalone Relay 2-Pole
WARNING! Executing a Factory Reset on a device may make it stop working as wanted and WILL remove it from the Z-Wave network. Please DO NOT execute this procedure unless it’s absolutely necessary.
Press and Hold the Add/Remove button for about 15 seconds - until LED indicator starts blinking. Then release the button. The device will now be factory reset and removed from the Z-Wave network.
The button is located about 10 mm down in the middle of the three holes on the front. A thin tool (a very small screwdriver, a toothpick, a paper clip or similar) is needed to access the button.
Please note that this is a user manual Standalone Relay 2-Pole from SE Devices is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Standalone Relay 2-Pole and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.