The following is an overview of the user manual for the Z-Wave product Sir 321 (MAX10Y-376)from Secure. To view other Z-Wave products and manuals from Secure follow that link.
Overview
With an external temperature sensor, SIR 321 can measure room temperature and send temperature report on regular interval or delta temperature change as per configuration.
It forms part of central heating control system, it can be operated by any third party controllers using ‘Binary Switch command class’ commands.
SIR 321 will act as a repeater once added into the Z- Wave network, providing an alternative communication route for units which otherwise would not be within communication distance of each other.
SIR 321 has a fail-safe mode where by the relay is turned OFF if another 'Binary switch SET' or 'Basic SET' command has not been received within 60 minutes.
Security
As a Z-Wave Plus certified product, Sir 321 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Secure describes Sir 321 as having the following features:
- Color
- Switch Load Capacity Watts
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
STEP 1: Ensure the RF LED is flashing on the SIR 321, if not than follow ‘Exclusion’ steps first.
STEP 2: Put the third party controller into inclusion mode.
STEP 3: Press and hold the pairing button on the SIR 321 until the RF LED start flashing at a fast rate. Then release the button.
The SIR 321 has been added onto the network when the RF LED stop flashing.
Factory reset Sir 321
"Please use this procedure only when the primary controller is missing or otherwise inoperable."
Press pairing button and boost button simultaneously until RF LED starts flashing to put the device in a factory default mode, all the configuration and association set to factory default and removing the device from Z-wave network.
1. SIR 321 can measure temperature if external temperature sensor is connected, delta change and interval temperature reporting also available with switch cut off feature as per configuration through configuration command class.
2. SIR 321 has a fail-safe mode where by the relay is turned OFF if another 'Binary Switch SET' or 'Basic SET' command has not been received within 60 minutes.
STEP 1: Put the third party controller into exclusion mode.
STEP 2: Press and hold the pairing button on the SIR 321 until the RF LED start flashing at a fast rate. Then release the button.
The SIR 321 has been removed from the network when the RF LED starts flashing.
Please note that this is a user manual Sir 321 from Secure is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Sir 321 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.