The following is an overview of the user manual for the Z-Wave product Smart LED Classic A19 CRI90 (V11-N13)from SENGLED . To view other Z-Wave products and manuals from SENGLED follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart LED Classic A19 CRI90 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
SENGLED describes Smart LED Classic A19 CRI90 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Security and non-Security features of bulb
Switch multilevel
If you would like to remove the bulb from your app, keep your bulb online and light on, then click the Exclusion button on your app, and power cycle the desired bulb once and keep on, it will be deleted from app automatically. Note: the bulb that you want to delete should be within the required time. If you want to delete another device, you should try the same operation again.
Factory reset Smart LED Classic A19 CRI90
To reset your Smart Z-Wave™ bulb to factory mode, ensure that the bulb is on firstly, then quickly turn the bulb off and on at least 5 times (using a light switch or power bar works best). If the reset is successful, the bulb will flash 3 times, and the device in app will be removed automatically. If it does not flash 3 times, you will have to try again. Once successfully reset, please try to pair it again.
Power cycle Sengled Smart Z-Wave™ bulb once within 2 seconds and keep the bulb on, it can go to the Inclusion mode. Then enable the Inclusion command in app can add the bulb successfully. If you would like to stop the Inclusion mode, power off the bulb more than 8 seconds, then you power on it, it can go to SmartStart mode again.
Please note that this is a user manual Smart LED Classic A19 CRI90 from SENGLED is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart LED Classic A19 CRI90 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.