The following is an overview of the user manual for the Z-Wave product Strips Comfort 700 (11 02 021)from Sensative . To view other Z-Wave products and manuals from Sensative follow that link.
Overview
Strip Comfort 700 can be configured to send temperature, humidity and ambient light reports periodically, or based upon changes from last report. It can also calculate and report the average temperature periodically. You can also set Strips Comfort 700 to send alert reports when a set temperature or light level has been reached.
Strips Comfort 700 comes with our +Switch slider that can be used to trigger scenarios or activate other devices such as lights or blinds.
Strips Comfort 700 supports associations to enable connectivity directly with other Z-Wave Plus™ devices without requiring a Z-Wave™ gateway.
Z-Wave Plus 700 series sensors bring a wealth of additional valued features such as longer range, low power consumption for an extended battery life and SmartStart technology for instant enrolling. With SmartStart, device inclusion can be initiated automatically by simply removing the included magnets. The Z-Wave gateway then performs the inclusion process in the background without the need for user interaction. 700 Series provides a direct range of 100 meters, an improvement of 60 meters over the 500 series and also includes the industry’s best S2 security, providing Strips with the ultimate combination of features for your smart home.
Security
As a Z-Wave Plus certified product, Strips Comfort 700 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Sensative describes Strips Comfort 700 as having the following features:
- Battery powered using Built in 3.0V LiMnO2 batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: "Start by scanning the Z-Wave QR Code present on the back label of the Strip, or on the DSK leaflet present in the box."
Place the controller into pairing mode and perform the "wake up" pattern as described below.
1. Take the magnet and move it to the rounded edge and wait for the blink, then move the magnet away.
2. Repeat this 3 times. A final short blink will confirm that the user-command was successful.
Place the controller into remove mode and perform the "wake up" pattern as described below.
1. Take the magnet and move it to the rounded edge and wait for the blink, then move the magnet away.
2. Repeat this 3 times. A final short blink will confirm that the user-command was successful.
1. Take the magnet and move it to the rounded edge and wait for the blink, then move the magnet away.
2. Repeat this 3 times. A final short blink will confirm that the user-command was successful.
Factory reset Strips Comfort 700
You may need to reset Strips if your Z-Wave controller is missing or not responding. Follow the instructions for Wake Up above, but on the 3rd
repetition, keep the magnet at the rounded edge for 10 seconds. A long LED signal indicates success.
Please note that this is a user manual Strips Comfort 700 from Sensative is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Strips Comfort 700 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.