The following is an overview of the user manual for the Z-Wave product Strips-MaZw (11 01 013)from Sensative . To view other Z-Wave products and manuals from Sensative follow that link.
Overview
It is as easy to mount as a sticker using Strips's adhesive tape.
Strips Guard is Z-Wave plus compliant and can be used with any existing Z-Wave smarthome systems.
Security
As a Z-Wave Plus certified product, Strips-MaZw supports Z-Wave S2 security. The following security modes are directly supported:
Features
Sensative describes Strips-MaZw as having the following features:
- Battery Quantity
- Battery powered using Built in 3.0V LiMnO2 batteries
- Color
- Outdoor Use
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Set the controller in remove mode (See your controller’s manual).
2. Place the round magnet at the rounded edge of Strips.
When the LED blinks, move the magnet away. Repeat 3 times in total within 10 seconds.
3. A long LED blink indicates that the remove process was successful.
Factory reset Strips-MaZw
Please use this procedure only when your Z-Wave controller is missing or otherwise inoperable:
1. Place the round magnet at the rounded edge of Strips.
2. When the LED blinks, move the magnet away. Repeat 3 times in total within 10 seconds.
3. On the 3rd repetition, leave the magnet at the rounded edge for 10s.
4. A long LED signal indicates success.
Wake up Strips manually for Z-Wave communication:
1. Place the round magnet at the rounded edge of Strips.
2. When the LED blinks, move the magnet away.
3. Repeat 3 times in total within 10 seconds.
Failure message: 5 LED blinks
Strips is delivered in ""auto-add"" mode.
Follow the process below to add Strips in a Z-Wave network.
1. Start the add mode on the Z-Wave controller.
See the controller’s manual.
2. Remove both magnets from Strips. Strips blinks twice to confirm the command and successful addition.
3. A long LED blink indicates that the add process was successful
4. The Z-Wave controller application should now allow you to monitor your Strips sensor status.
5. Move the squared magnet as shown in the picture . Check that the Z-Wave system indicates the status correctly.
6. If the Z-Wave system does not respond, it may be needed to change Strips’ notification type.
Manual add:
1. Set the controller to add mode (See your controller’s manual).
2. Place the round magnet at the rounded edge of Strips.
When the LED blinks, move the magnet away. Repeat 3 times in total within 10 seconds.
3. A long LED blink indicates that the add process was successful.
Please note that this is a user manual Strips-MaZw from Sensative is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Strips-MaZw and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.