Strips-Multi-sensor (11 02 017) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Strips-Multi-sensor (11 02 017)from Sensative . To view other Z-Wave products and manuals from Sensative follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


SKU Code
11 02 017
Strips, the ultra-thin multi sensor is now available in two new sensor models, Strips Drip and Strips Comfort. Drip and Comfort join Strips Guard, the thinnest magnet sensor in the world detecting if your windows are open and closed invisibly since 2015.

Strip Drip sends an alarm signal if it detects a water leak. Its unique design allows it to be easily placed almost everywhere, including most places other sensors simply can’t fit. With soaking pads integrated in the mounting plate even small amounts of water will be detected. The built-in temperature sensor gives the possibility to combine the leakage alarm with a freeze alarm. There is also a built-in ambient light sensor that may be useful in special applications.

Strips Comfort is a very accurate temperature and ambient light sensor. The unique design and mounting plate makes it easy to place almost invisibly in your home to measure temperature or control heating, air conditioning and even windows blinds which are connected to your Z-Wave smart home system.

All Strips products can be used both in-doors and out-doors and the integrated custom battery gives Strips an expected lifetime of up to 10 years. For you, this means no hassle needing to change or charge batteries in your Strips sensors for the lifetime of the products!
Version #
HW: 3 FW: 0.07:00.07 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Strips-Multi-sensor supports Z-Wave S2 security. The following security modes are directly supported:


    Sensative describes Strips-Multi-sensor as having the following features:

    • Battery powered using Built in 3.0V LiMnO2 batteries
    • Outdoor Use
    • Sensors
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Set your controller to add mode (see your controller’s manual). Follow the instruction for Wake up. A long LED blink indicates that the add/remove was successful.

    Set your controller to remove mode (see your controller’s manual). Follow the instruction for Wake up. A long LED blink indicates that the add/remove was successful.

    Factory reset Strips-Multi-sensor

    You may need to reset Strips if your Z-Wave controller is missing or not responding.

    Follow the instructions for “Wake up”, but on the 3rd repetition, leave the magnet at the rounded edge for 10 seconds. A long LED signal indicates success.

    Wake up Strips manually for Z-Wave communication. Place the magnet at the rounded edge. When the LED blinks, move the magnet away. Repeat twice within 10 seconds.

    Please note that this is a user manual Strips-Multi-sensor from Sensative is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Strips-Multi-sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.