The following is an overview of the user manual for the Z-Wave product Door/window sensor (ZC-100)from Sentek. To view other Z-Wave products and manuals from Sentek follow that link.
Overview
advantage of Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
The Sentek Door / Window Sensor is designed for use with scenes in home automation systems, alarm and surveillance systems and everywhere else where information related to opening / closing of doors, windows, garage gates, etc. is needed. Suitable for smart home systems.
Security
As a Z-Wave Plus certified product, Door/window sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Sentek describes Door/window sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1.Install the device for correct positioning of
the Sensor and the magnet according to the manual.
2.Set the Z-Wave controller to the inclusion mode.
3.The ZC-100 Door/Window Sensor is added to the network by quickly
pressing the TMP button three times .
4. Correct inclusion of the device to the network will be signalled by
the Z-Wave controller.
Factory reset Door/window sensor
Note: Use the reset procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Pressed the TMP button more than 5 seconds.
2. Release the TMP button while the device's Led start blinking.
3. Reset is performed.
Any action of TMP button and the magnetic sensor will wakeup the product. And by default every 5 minutes the product will wakeup.
1.Install the device for correct positioning of
the Sensor and the magnet according to the manual.
2.Set the Z-Wave controller to the exclusion mode.
3.The ZC-100 Door/Window Sensor is delete from the network by quickly
pressing the TMP button three times.
4. Correct exclusion of the device from the network will be signalled by
the Z-Wave controller.
Please note that this is a user manual Door/window sensor from Sentek is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/window sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.