The following is an overview of the user manual for the Z-Wave product PIR motion sensor (ZM-800WU)from Sentek. To view other Z-Wave products and manuals from Sentek follow that link.
Overview
Integration with anti-RF interference, high temperature protection and noise suppression technology, ZM-800 has high tolerance with local temperature changes caused by the curtain or sunlight and the detection accuracy is quite high.
Security
As a Z-Wave Plus certified product, PIR motion sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Sentek describes PIR motion sensor as having the following features:
- Sensors
- Switch Type
- Battery Quantity
- Battery powered using ER14505-2700mAH batteries
- Outdoor Use
- Color
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Make sure ZM-800 is in the range of the Z-Wave controller.
2. Set the Z-Wave controller to the inclusion mode.
3. Quickly pressing TP-Switch2 button 3 times on the ZM-800.
4. The ZM-800 is added to the network .
1. Make sure ZM-800 is in the range of the Z-Wave controller.
2. Set the Z-Wave controller to the exclusion mode.
3. Quickly pressing TP-Switch2 button 3 times on the ZM-800.
4. The ZM-800 is deleted from the network .
Factory reset PIR motion sensor
Note: Use the reset procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Presse the TP-Switch2 button more than 5 seconds.
2. Z-Wave LED is start blinking.
3. Release the TP-Switch2 button right now.
4. Z-Wave LED off, reset is performed.
Any action of TP-switch button and the PIR sensor will wakeup the product. And by default every 5 minutes the product will wakeup itself.
Please note that this is a user manual PIR motion sensor from Sentek is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR motion sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.