The following is an overview of the user manual for the Z-Wave product Z-Wave Smart Chime (Sound Switch) (SW-SCM01N)from Sercomm. To view other Z-Wave products and manuals from Sercomm follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Smart Chime (Sound Switch) supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Sercomm describes Z-Wave Smart Chime (Sound Switch) as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Smart Chime (Sound Switch)
1. Hold the Paring button for 10 second until the LED lights up.
2. When LED turns off, all Z-Wave information will be cleared, the Node ID will be excluded from the device, and all settings will be reset to factory defaults.
Note: Please use this procedure only when the network's primary controller is missing or otherwise inoperable.
1. Follow your Z-Wave controller's instructions on how to put the controller into ""Remove"" mode.
2. Press the Pairing button once.
3. The LED will blink for one second while the device is being removed from the network.
4. If the device was successfully removed from the network, all Z-Wave information will be cleared,
and the Node ID will be excluded from the device.
Auto inclusion:
1. Follow your Z-Wave controller's instructions on how to put the controller into ""Add"" mode.
2. Power on the device.
3. The LED will blink during the inclusion process. This process may take up to 4 minutes.
4. If the device is successfully added to the network, the LED will turn off. The device will return to normal operation.
If the process fails, try repeating steps 1 - 3 again.
Manual inclusion:
1. Follow your Z-Wave controller's instructions on how to put the controller into ""Add"" mode.
2. Press the Paring button once to put the device into inclusion mode.
3. The LED will blink during the inclusion process. This process may take up to 4 minutes.
4. If the device is successfully added to the network, the LED will turn off. The device will return to normal operation.
If the process fails, try repeating steps 1 - 3 again.
Please note that this is a user manual Z-Wave Smart Chime (Sound Switch) from Sercomm is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Smart Chime (Sound Switch) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.