Multi Sensor (DN3G6JA069) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Multi Sensor (DN3G6JA069)from Sharp Corporation. To view other Z-Wave products and manuals from Sharp Corporation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Multi Sensor
SKU Code
DN3G6JA069
Description
The Multi Sensor is a product for IoT with several sensors and with functions of Z-Wave communication. It can collect sensing data that temperature, humidity, Luminance, human motion, and door open/close by using a magnet. And it sends the data to the gateway.

The Multi Sensor has the following general features:
- Z-Wave communication
- Sensing with the following
Temperature sensor,
Humidity sensor,
Luminance sensor,
Human detect sensor (motion sensor by pyroelectric infrared sensor),
Open/Close sensor (detecting the opening and shutting of the door by using a magnet),
Tamper switch.

Version #
HW: 255 FW: 0.80 was the version certified
Certification #
ZC10-18066133
Certified
2018-03-12T16:22:45.481032
Z-Wave Version
6.71.03

Security

As a Z-Wave Plus certified product, Multi Sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Sharp Corporation describes Multi Sensor as having the following features:

  • Sensors
  • Supported Notification Types
  • Battery powered using CR123A batteries
  • Battery Quantity
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Set the controller to the status for “Remove”.
Press the button over 3 seconds and release.
LED blinks when “Remove” is completed.

Insert a CR123A, and LED blinks.
Set the controller to the status for “Add”.
Press the button over 3 seconds and release.
About 30 second later, LED turns off when “Add” is completed.

Factory reset Multi Sensor

Press the button over 10 seconds and release.

Briefly press the button once.

Please note that this is a user manual Multi Sensor from Sharp Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multi Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.