The following is an overview of the user manual for the Z-Wave product Z-Wave Gateway (DN3E6JA087)from Sharp Corporation. To view other Z-Wave products and manuals from Sharp Corporation follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Gateway supports Z-Wave S2 security. The following security modes are directly supported:
Features
Sharp Corporation describes Z-Wave Gateway as having the following features:
- Supported Notification Types
- Color
- Door Lock Type
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To remove a device from the Z-Wave network, press “Exclusion” button in Mobile Application or hold down the Z-Wave button of the product (over 3 seconds). This will put the product into Exclusion mode and Z-Wave LED blinks quickly.
To add a device to the Z-Wave network, press “Inclusion” button in Mobile Application or press the Z-Wave button of the product once. This will put the product into Inclusion mode and Z-Wave LED blinks slowly.
When you tap the Setting button in Moble Application, Settings dialog is displayed. Then select ""Learn Mode"", and this will put the product into Learn mode.
Factory reset Z-Wave Gateway
When you tap the Setting button in Moble Application, Settings dialog is displayed. Then select ""Reset"" and press “RESET” button in Factory Default Reset dialog. This will reset the Z-Wave chip and all LEDs blinks, and the product will broadcast the “DEVICE RESET LOCALLY NOTIFICATION” after restart.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Gateway from Sharp Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.