Z-Wave DOOR SENSOR (IM20-Z-Wave) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave DOOR SENSOR (IM20-Z-Wave)from Shenzhen Kaipule Technology Co., Ltd.. To view other Z-Wave products and manuals from Shenzhen Kaipule Technology follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


SKU Code
IM20_Zwave is a door/window sensor adopting Zwave500 series chip. It uses special structure design, suitable for kinds of installation environments. Also, it supports door & window open/close detection, anti-tamper, battery level detection and associated gateway and interaction device notifications.
Version #
HW: 255 FW: 1.38 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave DOOR SENSOR supports Z-Wave S2 security. The following security modes are directly supported:


    Shenzhen Kaipule Technology describes Z-Wave DOOR SENSOR as having the following features:

    • Battery Quantity
    • Battery powered using AAA batteries
    • Color
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    enter the Inclusion Mode of gateway, and press the tamper switch 3 times within 1.5s,then the door sensor will stay in enrollment state until successfully enrolled into network or enrollment time out after 30s.

    enter the Exclusion Mode of gateway, and press the tamper switch 3 times within 1.5s, then the door sensor will be removed after a period of time.

    Factory reset Z-Wave DOOR SENSOR

    Press the tamper switch 6 times in 2s, it will recover to factory setting after a period of timeļ¼ˆPlease use the reset procedure only when the primary controller is missing or inoperableļ¼‰

    a) Manual Wake-up
    Quickly press tamper switch once, the door sensor will automatically send wake-up information, and there will be 10s after wake-up to receive gateway setting information.
    b) Automatic Wake-up
    Default time of automatic wake-up is 24 hours, and there will be 10s after wake-up to receive gateway setting information, the max automatic report time = 24 hours, minimum=30min

    Please note that this is a user manual Z-Wave DOOR SENSOR from Shenzhen Kaipule Technology Co., Ltd. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave DOOR SENSOR and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.