Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Dimmer Switch (ZW31T) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Dimmer Switch (ZW31T)from show home. To view other Z-Wave products and manuals from show home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Dimmer Switch
SKU Code
ZW31T
Description
It is an In-wall type device controlled by Z-Wave controller and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can dim lights at home from your mobile phone separately, and manual dim light by push button .
Version #
HW: 1 FW: 20.15 was the version certified
Certification #
ZC10-16105263
Certified
2016-10-07T12:18:54.3284
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, In-Wall Dimmer Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    show home describes In-Wall Dimmer Switch as having the following features:

    • Electric Load Type
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, triple press the Up/Down push button to exclude it from the network.

    Factory reset In-Wall Dimmer Switch

    1. Use controller to remove device from network will reset it to factory default.
    2. Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, triple press the Up/Down push button to include it into the network.
    3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.
    4. The device is associated in the same group when it included in setting process.

    Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed. If your controller features remote access, you can now control all devices in Z-Wave network from mobile devices.

    Please note that this is a user manual In-Wall Dimmer Switch from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Dimmer Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.