Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Dimmer (ZW31) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Dimmer (ZW31)from show home. To view other Z-Wave products and manuals from show home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Dimmer
SKU Code
ZW31
Description
It is an In-wall type device controlled by Z-Wave controller and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can dim lights at home from your mobile phone separately, and manual dim light by push button .
Version #
HW: 1 FW: 20.15 was the version certified
Certification #
ZC10-16065099
Certified
2016-05-27T13:53:14.4132
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, In-Wall Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    show home describes In-Wall Smart Dimmer as having the following features:

    • Electric Load Type
    • Firmware updatable via a compatible Z-Wave gateway
    • Color
    • IP (Ingress Protection) Rated
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • Outdoor Use
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, triple press the Up/Down push button to include it in the network.
    3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.
    4. The device is associated in the same group when it included in setting process.
    Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.

    1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
    Once the controller is ready to Exclude your device, triple press the Up/Down push button to exclude it from the network.

    Factory reset In-Wall Smart Dimmer

    Use controller to remove device from network will reset it to factory default.

    *Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-Wall Smart Dimmer from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.