The following is an overview of the user manual for the Z-Wave product In-Wall Smart Switch (ZW30T)from show home. To view other Z-Wave products and manuals from show home follow that link.
Overview
Security
As a Z-Wave Plus certified product, In-Wall Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
show home describes In-Wall Smart Switch as having the following features:
- Electric Load Type
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Neutral Wire Required
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions of certified controller to include a device from
different manufactures into the Z-Wave network.
2. Once the controller is ready to include your device, triple press the Up/Down
push button to include it in the network.
3. Once your controller has confirmed that the device has been included,
refresh the Z-Wave network to optimize performance.
4. The device is associated in the same group when it included in setting
process. Now you can control your Z-Wave device according to groups,
scenes, schedules and automation programmed. If your controller features
remote access, you can now control all devices in Z-Wave network from mobile devices.
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, triple press the
Up/Down push button to exclude it from the network.
Factory reset In-Wall Smart Switch
1. Use controller to remove device from network will reset it to factory default.
2. Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart Switch from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.