The following is an overview of the user manual for the Z-Wave product Siren Box (ZW15)from show home. To view other Z-Wave products and manuals from show home follow that link.
Overview
Security
As a Z-Wave Plus certified product, Siren Box supports Z-Wave S2 security. The following security modes are directly supported:
Features
show home describes Siren Box as having the following features:
- Battery powered using AAA batteries
- Color
- Switch Type
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Siren Box
Press and hold ADD Button for at least 3 seconds while you insert batteries.
Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable
1. Follow the instructions for your Z-Wave certified controller to include a device to
the Z-Wave network.
2. Once the controller is ready to include your device, triple click the ADD
Button to include it in the network.
3. Once your controller has confirmed that the device has been included, refresh the
Z-Wave network to optimize performance.
1. Follow the instructions for your Z-Wave certified controller to exclude a device
from the Z-Wave network.
2. Once the controller is ready to Exclude your device, triple click the ADD Button
to exclude it from the network.
Please note that this is a user manual Siren Box from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Siren Box and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.