Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Plug(built-in energy meter) (ZW38) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Plug(built-in energy meter) (ZW38)from show home. To view other Z-Wave products and manuals from show home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Plug(built-in energy meter)
SKU Code
ZW38
Description
This smart plug provides one Z-Wave outlet with power and send out the consumption data for remote controller through Z-Wave gateway for internet of thing service and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can now control your device from your mobile phone devices. And get summary data for daily/month power or energy used for this load while installed an App on your mobile. Manual On/Off by push button on front. The outlet has maximum load for 600W Incandescent or 1200W resistive.
Version #
1.1.2 was the version certified
Certification #
ZC10-17085720
Certified
2017-08-04T20:15:51.521446
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Smart Plug(built-in energy meter) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    show home describes Smart Plug(built-in energy meter) as having the following features:

    • Supported Meter Type
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • Color
    • Electric Load Type
    • Switch Load Capacity Current
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to exclude
    a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press up and
    release the button to exclude it from the network.

    1. Follow the instructions for your Z-wave certified controller to exclude a device
    from the Z-wave network.
    2. Once the controller is ready to Exclude your device, press up and release the
    toggle to exclude it from the network.
    Note:

    Factory reset Smart Plug(built-in energy meter)

    Press and hold the top button for at least 3 seconds while you plug the smart switch into a receptacle.

    ""Use this procedure only in the event that the network primary controller is missing or otherwise inoperable""

    Please note that this is a user manual Smart Plug(built-in energy meter) from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug(built-in energy meter) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.