Smart Plug Dimmer (ZW39) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Plug Dimmer (ZW39)from show home. To view other Z-Wave products and manuals from show home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Smart Plug Dimmer
SKU Code
The Plug provides Z-Wave outlet controlled by controller and can be configured in Z-Wave sensor network and you can control outlet with dimmer function from your mobile phone and manual dim the light by front button.
Version #
HW: 1 FW: 20.15 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Smart Plug Dimmer supports Z-Wave S2 security. The following security modes are directly supported:


    show home describes Smart Plug Dimmer as having the following features:

    • Color
    • Electric Load Type
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Current
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, quick triple press the button to include it into the network.
    3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.
    4. The device is associated in the same group when it included in setting process.
    Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.

    1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, quick triple press the button to exclude it from the network.

    Factory reset Smart Plug Dimmer

    Use controller to remove device from network will reset it to factory default.

    ""Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.""

    Please note that this is a user manual Smart Plug Dimmer from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Smart Plug Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.