Smart Plug switch (ZW96) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Plug switch (ZW96)from show home. To view other Z-Wave products and manuals from show home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Smart Plug switch
SKU Code
The smart plug provides one Z-Wave outlet for remote controlled by controller and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can now control your device from your mobile phone devices. The outlets have maximum load for 600W Incandescent, ½ HP motor or 1800W resistive.
Version #
HW: 0 FW: 20.15 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Smart Plug switch supports Z-Wave S2 security. The following security modes are directly supported:


    show home describes Smart Plug switch as having the following features:

    • Color
    • Electric Load Type
    • Switch Load Capacity Volt-Ampere
    • Switch Load Capacity Watts
    • Outdoor Use
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to
    include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, press up and
    release the toggle to include it in the network.
    3. Once your controller has confirmed that the device has been
    included, refresh the Z-Wave network to optimize performance.
    4. The device is associated in the same group when it included in
    setting process.

    Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.

    1. Follow the instructions for your Z-Wave certified controller to
    exclude a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press up and
    release the front button to exclude it from the network.

    Factory reset Smart Plug switch

    1. Press and hold the top button for at least 3 seconds while you plug the smart switch into a receptacle.
    2. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Smart Plug switch from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Smart Plug switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.