The following is an overview of the user manual for the Z-Wave product Smoke Sensor (ZW1103)from show home. To view other Z-Wave products and manuals from show home follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smoke Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
show home describes Smoke Sensor as having the following features:
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Sensors
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Smoke Sensor
Press and hold ADD Button for at least 3 seconds while you insert the battery.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable
The sensor was wake up when Test Button on or sensor detect smoke after mounted on site.
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
2. Once the controller is ready to include your device, triple click the ADD Button to include it in the network.
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, triple click the ADD Button to exclude it from the network.
Please note that this is a user manual Smoke Sensor from show home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smoke Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.