The following is an overview of the user manual for the Z-Wave product HUB iO (10003041-13X)from Simon. To view other Z-Wave products and manuals from Simon follow that link.
Overview
It allows you manage your entire Z-Wave network and add new features to your life making it more confortable.
Use it through your Simon 100 APP in order to manage features and configurations of your switches and sockets, no matter if you are at home or not.
Security
As a Z-Wave Plus certified product, HUB iO supports Z-Wave S2 security. The following security modes are directly supported:
Features
Simon describes HUB iO as having the following features:
- Supported Meter Type
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- Switch Load Capacity Current
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
If HUB iO is linked to APP Simon 100 --> using the APP according Simon 100 Guide instructions. Using the APP according Simon 100 Guide instructions. Using the APP according Simon 100 Guide instructions. Pressing pushbutton t>30s. Please note that this is a user manual HUB iO from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have HUB iO and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.
Otherwise pressing pushbutton for 2s
There are 2 options:
1.- USING APP:
In order to perform this action go to MENU > iO > Installation Data > Advanced Settings > Replicate controller or Update HUB.
HUB iO will join to Learn mode in order to be added in other Z-Wave Controller.
NOTE:
(This option is only available if none device has been added to HUB iO network or if HUB iO is not the Main controller (SIS) of the network.)
2.- USING Local button
If your Simon 100 iO APP is not linked with Simon 100 HUB iO you can perform this action press left button during 3 seconds.
NOTE:
This option is only available if HUB iO is not linked with Simon 100 iO APP.
There are 2 options:
1.- USING APP:
In order to perform this action go to MENU > iO > Installation Data > Advanced Settings > Replicate controller or Update HUB.
HUB iO will join to Learn mode in order to be added in other Z-Wave Controller.
NOTE:
(This option is only available if none device has been added to HUB iO network or if HUB iO is not the Main controller (SIS) of the network.)
2.- USING Local button
If your Simon 100 iO APP is not linked with Simon 100 HUB iO you can perform this action press left button during 3 seconds.
NOTE:
This option is only available if HUB iO is not linked with Simon 100 iO APP.Factory reset HUB iO
Or removing HUB iO using the APP.
If HUB iO is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If HUB iO is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.