Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

S100 IO Socket 10A (China) (10002038-13X) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product S100 IO Socket 10A (China) (10002038-13X)from Simon. To view other Z-Wave products and manuals from Simon follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
S100 IO Socket 10A (China)
SKU Code
10002038-13X
Description
Socket iO is ready to operate with Z-Wave controllers and configured to be managed by Simon100 iO APP using the HUB plug iO for getting a better user experience. allowing the control of the socket and LEDs integrated.

Available colors Black and White.

visit http://www.simon.es/simon100/ to learn more about Simon 100 iO.
Version #
HW: 1 FW: 4.24:68.49 was the version certified
Certification #
ZC10-19076674
Certified
2019-07-16T21:53:41.419405
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, S100 IO Socket 10A (China) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Simon describes S100 IO Socket 10A (China) as having the following features:

    • Neutral Wire Required
    • Firmware updatable via a compatible Z-Wave gateway
    • Supported Meter Type
    • Switch Load Capacity Current
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset S100 IO Socket 10A (China)

    When the pushbutton is released after a press of (30sec
    Main LED will perform 1 Blink with 5 sec.

    Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    When the pushbutton is released after a press of (2sec Central LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Central LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    When the pushbutton is released after a press of (2sec Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    Please note that this is a user manual S100 IO Socket 10A (China) from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S100 IO Socket 10A (China) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.