Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

S100 Master Rocker for Roller Blind (Mexico) (10005081-13x) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product S100 Master Rocker for Roller Blind (Mexico) (10005081-13x)from Simon. To view other Z-Wave products and manuals from Simon follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
S100 Master Rocker for Roller Blind (Mexico)
SKU Code
10005081-13x
Description
Master Roller Blind IO is ready to operate with Z-Wave controllers and configured to be managed by Simon100 IO APP using the HUB plug IO for getting a better user experience. Sending the Blind controller by other window covering devices Up/Down/Stop.
Version #
HW: 1 FW: 4.24:76.51 was the version certified
Certification #
ZC10-20016839
Certified
2020-01-13T11:13:23.641711
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, S100 Master Rocker for Roller Blind (Mexico) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Simon describes S100 Master Rocker for Roller Blind (Mexico) as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Neutral Wire Required
    • Z-Wave Scene Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the pushbutton is released after a press of (2sec Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    Factory reset S100 Master Rocker for Roller Blind (Mexico)

    When the pushbutton is released after a press of (30sec
    Main LED will perform 1 Blink with 5 sec.

    Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    When the pushbutton is released after a press of (10sec Central LED will blink slow during Association mode time.
    Association mode allows add devices to Device Group 2.
    If associated devices are Simon Devices, Master will turn on Central LED to inform the user about which devices are in.
    Once association is finished, Master will turn off the Central LED to allow the normal use of the devices.

    When the pushbutton is released after a press of (2sec Central LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    Please note that this is a user manual S100 Master Rocker for Roller Blind (Mexico) from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S100 Master Rocker for Roller Blind (Mexico) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.