Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

S100 Rocker for Dimmer (China) (10003020-13X) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product S100 Rocker for Dimmer (China) (10003020-13X)from Simon. To view other Z-Wave products and manuals from Simon follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
S100 Rocker for Dimmer (China)
SKU Code
10003020-13X
Description
Simon iO Dimmer is integrated by Electronic Dimmer and a Rocker, that provides Z-Wave communication attributes. The touch surface offers an slider area in order to adjust the light level showing the dimming intensit y with 7 LEDs .

Simon iO Dimmer is ready to operate with Z-Wave controllers and configured to be managed by Simon100 IO APP using the HUB plug IO for getting a better user experience.
Version #
HW: 1 FW: 4.24:78.59:70.48 was the version certified
Certification #
ZC10-19046438
Certified
2019-04-25T23:58:48.66665
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, S100 Rocker for Dimmer (China) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Simon describes S100 Rocker for Dimmer (China) as having the following features:

    • Switch Load Capacity Watts
    • Firmware updatable via a compatible Z-Wave gateway
    • Supported Meter Type
    • Electric Load Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the pushbutton is released after a press of (2sec Central LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    When the pushbutton is released after a press of (2sec Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    When the pushbutton is released after a press of (10sec All LEDs will Blink with 0,3 sec period to inform that callibration is going to be performed.
    After release and during the callibration All LEDs will Blink with 0,3 sec period to inform that callibration process is being performed.

    When the pushbutton is released after a press of (15sec

    Factory reset S100 Rocker for Dimmer (China)

    When the pushbutton is released after a press of (30sec
    Main LED will perform 1 Blink with 5 sec.

    Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual S100 Rocker for Dimmer (China) from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S100 Rocker for Dimmer (China) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.