The following is an overview of the user manual for the Z-Wave product S100 Rocker for Dimmer (Mexico) (10005020-13x)from Simon. To view other Z-Wave products and manuals from Simon follow that link.
Overview
Simon iO Dimmer is ready to operate with Z-Wave controllers and configured to be managed by Simon100 IO APP using the HUB plug IO for getting a better user experience.
Security
As a Z-Wave Plus certified product, S100 Rocker for Dimmer (Mexico) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Simon describes S100 Rocker for Dimmer (Mexico) as having the following features:
- Switch Load Capacity Watts
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Long key press between 2 and 10 seconds. Central LED blinks until release
of Pushbutton
Long key press between 2 and 10 seconds. Central LED blinks until release
of Pushbutton
Factory reset S100 Rocker for Dimmer (Mexico)
Long press for more than 30 seconds. The central LED light up for
2.5 sec.
Please use this procedure only when the network primary controller is missing or otherwise inoperable
Please note that this is a user manual S100 Rocker for Dimmer (Mexico) from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S100 Rocker for Dimmer (Mexico) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.