Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

S100 Rocker iO for Dimmer (10002020-13X) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product S100 Rocker iO for Dimmer (10002020-13X)from Simon. To view other Z-Wave products and manuals from Simon follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
S100 Rocker iO for Dimmer
SKU Code
10002020-13X
Description
Simon iO Dimmer is ready to operate with Z-Wave controllers and configured to be managed by Simon100 IO APP using the HUB plug IO for getting a better user experience. Sending the Blind Up/Down or setting a specific position.
Version #
HW: 1 FW: 4.24:78.59:70.48 was the version certified
Certification #
ZC10-18026010
Certified
2018-01-09T22:30:36.947769
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, S100 Rocker iO for Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Simon describes S100 Rocker iO for Dimmer as having the following features:

    • Neutral Wire Required
    • Firmware updatable via a compatible Z-Wave gateway
    • Electric Load Type
    • Switch Load Capacity Watts
    • Supported Meter Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the pushbutton is released after a press of (2sec Central LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    When the pushbutton is released after a press of (2sec Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    Factory reset S100 Rocker iO for Dimmer

    When the pushbutton is released after a press of (30sec
    Main LED will perform 1 Blink with 5 sec.

    Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    When the pushbutton is released after a press of (10sec All LEDs will Blink with 0,3 sec period to inform that callibration is going to be performed.
    After release and during the callibration All LEDs will Blink with 0,3 sec period to inform that callibration process is being performed.

    When the pushbutton is released after a press of (15sec

    Please note that this is a user manual S100 Rocker iO for Dimmer from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S100 Rocker iO for Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.