The following is an overview of the user manual for the Z-Wave product S100 Switch IO (Mexico) (10005034-13x)from Simon. To view other Z-Wave products and manuals from Simon follow that link.
Overview
Security
As a Z-Wave Plus certified product, S100 Switch IO (Mexico) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Simon describes S100 Switch IO (Mexico) as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Supported Meter Type
- Switch Load Capacity Current
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
When the pushbutton is released after a press of (2sec
This process does not perform a default reset of configurations.
Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.
When the pushbutton is released after a press of (2sec
This process does not perform a default reset of configurations.
Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.
Factory reset S100 Switch IO (Mexico)
When the pushbutton is released after a press of (20sec
Main LED will perform 1 Blink with 5 sec.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Switch IO is ready to operate with Z-Wave controllers and configured to be managed by Simon100 IO APP using the HUB plug IO for getting a better user experience.
Please note that this is a user manual S100 Switch IO (Mexico) from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S100 Switch IO (Mexico) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.