Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Sensor de humo iO (10002862-039) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Sensor de humo iO (10002862-039)from Simon. To view other Z-Wave products and manuals from Simon follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Sensor de humo iO
SKU Code
10002862-039
Description
Photoelectric smoke alarm is generally more effective at detecting slow, smoldering fires that smolder for hours before bursting into flame. Install a smoke alarm in every room and on every level of the house. Once detected smoke concentration reaches the threshold value, its red LED indicator will flashes quickly and it will give out loud alarm sound, and an alarm message will also be sent to user APP to alert the user to take action ASAP.
Version #
HW: 255 FW: 3.01 was the version certified
Certification #
ZC10-20076951
Certified
2020-07-24T13:51:05.314147
Z-Wave Version
6.71.03

Security

As a Z-Wave Plus certified product, Sensor de humo iO supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Simon describes Sensor de humo iO as having the following features:

  • Communications Connections
  • Color
  • Battery Quantity
  • Battery powered using CR123A, CR17335 batteries
  • Communications Protocol
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Device Remove for Exclusion
- Click [Remove] icon in Z-Wave Controller
- Press the Net_Button for between 2 and 30 seconds, Green LED is Blinking one time every 300 milliseconds.

Factory reset Sensor de humo iO

-Long press Net_Button for more than 30 secounds in the product.
- Device Reset Locally notification is Transmitted.Green led is turn on for 2.5 seconds，then turn off.

. Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Device ADD for Inclusion
- Click [Add] icon in Z-Wave Controller .
- Press the Net_Button for between 2 and 30 seconds, Green LED is Blinking one time every 300 milliseconds.
- If Inclusion Process is successful, Green led will turn off.

- Wake up Notification is transmitted every 24 hours by default.
- Wake up Notification is transmitted when power is turn on.
- Press Net_Button for 2 seconds between 30 seconds

Please note that this is a user manual Sensor de humo iO from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Sensor de humo iO and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.