Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Switch IO (10002034-13x && 10000322-039) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Switch IO (10002034-13x && 10000322-039)from Simon. To view other Z-Wave products and manuals from Simon follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Switch IO
SKU Code
10002034-13x && 10000322-039
Description
Simon Electronic Switch IO integrated by Electronic Switch that provides power Switch and Rocker that provides Z-Wave communication attributes.
Version #
HW: 1 FW: 4.18.72.15.65.15 was the version certified
Certification #
ZC10-16115315
Certified
2016-11-21T18:10:43.176536
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Switch IO supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Simon describes Switch IO as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Current
    • Neutral Wire Required
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the pushbutton is released after a press of (2sec Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    When the pushbutton is released after a press of (2sec Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    This process does not perform a default reset of configurations.

    Main LED will Blink with 0,3 sec period to inform that NIF can be send after release of pushbutton.

    Factory reset Switch IO

    When the pushbutton is released after a press of (20sec
    Main LED will perform 1 Blink with 5 sec.

    Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    Switch IO is ready to operate with Z-Wave controllers and configured to be managed by Simon100 IO APP using the HUB plug IO for getting a better user experience.

    Please note that this is a user manual Switch IO from Simon is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Switch IO and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.