The following is an overview of the user manual for the Z-Wave product Heat Alarm (GS412B)from siterwell. To view other Z-Wave products and manuals from siterwell follow that link.
Overview
included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers under the same radio frequency. It is the point that only under same radio frequency the heat alarm can be included and operated. All non-battery operated alarms within the network will act as repeaters, as to increase reliability of the network. In the Z-Wave network communication, the heat alarm can communicate with other devices associated. Through the Z-Wave network controller, you can get the status of the alarm, such as battery level.
Security
As a Z-Wave Plus certified product, Heat Alarm supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
siterwell describes Heat Alarm as having the following features:
- Battery Quantity
- Supported Notification Types
- Battery powered using AA batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Heat Alarm
This operation will delete all information on Z-Wave network, and restore the factory default setting.
1. Remove the battery.
2. Press the button and don't release. And then connect the battery, the red light will on 3 seconds,3 seconds later, then release the button when the red light is off.
3. The red light is on for 3 seconds when the button is released. During these 3 seconds, press the button. Only after hearing a beep, restore factory settings successfully.
Note:
a. Please use this procedure only when the network main controller is missing or inoperable.
1. Make sure the battery is installed well before operating the product.
2. Set the main controller into the remove (exclusion ) mode.
3. Quickly press the test button three times within two seconds, the red LED will light up.
4. Wait for the main controller to remove(exclusion) the alarm. If the remove(exclusion) is successful, the red LED flashes for about two seconds, and then exit the remove mode automatically.
Note:
a. If the alarm is removed(excluded), the alarm will be restored to factory default settings.
b.When the alarm is in “Add” or “Remove” mode, you can press the test button to exit and return to operating mode.
The heat alarm can be included to the Z-Wave network by following operations:
1. Make sure the battery is installed well before operating the product.
2. Make sure the alarm is on its final installation position, and then set a main controller into the add (inclusion ) mode.
3. Quickly press the test button three times within two seconds, the red LED will light up.
4. If the red LED flashes for about two seconds, it indicates that the alarm have been added (included) successfully, otherwise repeat the operation accordingly.
Please note that this is a user manual Heat Alarm from siterwell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Heat Alarm and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.