The following is an overview of the user manual for the Z-Wave product Power plug Sensor (STW-W3350WU)from Siterwell Technology. To view other Z-Wave products and manuals from siterwell follow that link.
Overview
In the front casing, there is button that is used to carry out include, exclude or reset factory default settings on PCB Board.
When power is first supplied, the LED will flash on and off with yellow alternately every 1 second intervals within 5 seconds if the detector has not been added a Z‐Wave network, otherwise the LED will flash on and off 5 times with cyan alternately every 300 millisecond. Please get familiar with the terms below before starting the operations.
This Plug has function that remembers the relay states, the plug will turn on after power up next time if the plug is turn on before the power cut‐off.
Security
As a Z-Wave Plus certified product, Power plug Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
siterwell describes Power plug Sensor as having the following features:
- Color
- Switch Load Capacity Volt-Ampere
- Supported Meter Type
- Switch Type
- Supported Notification Types
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add the Device (Smart Plug) to Z‐Wave Network
1.Make sure the sensor is powered.
2.Set Z‐Wave controller or Z‐Wave gateway into inclusion mode (Refer to the controller or gateway operating manual)
3.Press the button three times within 1.5 second, the device will enter inclusion mode. And the LED will flash on and off with green alternately five times within 2 seconds.
Delete the Device (Smart Plug) from Z‐Wave Network
1.Make sure the sensor is powered.
2.Set Z‐Wave controller or Z‐Wave gateway into exclusion mode (Refer to the controller or gateway operating manual)
3.Press the button three times within 1.5 second, the device will enter exclusion mode. And the LED will flash on and off with yellow alternately five times within 2 seconds.
Factory reset Power plug Sensor
Note: to use the reset procedure only when the primary controller is missing or inoperable.
Restore the Device (Smart Plug) to Factory Default Settings
Reset procedure will delete all information on the Z‐Wave network and Z‐Wave controller or Z‐Wave Gateway, and restore the sensor to factory default settings.
1.Make sure the sensor is powered.
2.Press and hold the button more than 10 seconds until the LED blink with red color.
3.Release the button.
Please note that this is a user manual Power plug Sensor from Siterwell Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power plug Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.