The following is an overview of the user manual for the Z-Wave product Smoke Alarm Sensor (GS559B)from siterwell. To view other Z-Wave products and manuals from siterwell follow that link.
Overview
The smoke alarm is an intelligent security equipment that can be controlled by the Z-Wave network which has particular frequency. Different countries or areas, the radio frequency of the Z-Wave is different. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. In the Z-Wave network communications, the smoke alarm can communicate with other devices associated. When the smoke is detected, the sensor will send messages to the main controller, and then the alarm sound. Through the Z-Wave network, the devices associated can response after smoke is detected, For instance , Start fire extinguishing equipment and trigger an alarm, Through the Z-Wave network controller, You will be notified in case of fire.
Security
As a Z-Wave Plus certified product, Smoke Alarm Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
siterwell describes Smoke Alarm Sensor as having the following features:
- Supported Notification Types
- Battery Quantity
- Battery powered using AA batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add(Including) alarm to Z-Wave Network
1:Make sure the battery is installed well before operating the product.
2:Make sure the alarm is on its final install location, then set the controller into the Add(Inclusion )mode.
3:Quickly, triple click the test button, The LED will light up.
4:Issued beep, LED off, the alarm being Add (included)to the network successfully.
1: Make sure the battery is installed well before operating the product.
2: Set the Z-Wave Network controller into Remove(exclusion) mode.
3:Quickly, triple click the test button, The LED will light up and alarm enter
Remove(Excluding) Mode.
4:Wait for the main controller to Remove(exclusion) the alarm.
Note: If the alarm is Remove(excluded), then the sensor will be itselfrestored to factory default settings.
Factory reset Smoke Alarm Sensor
Reset will delete all information on the Z-Wave network controller, and restore the alarm to factory default settings.
1: Press and hold the test button , Installing the battery, red LED light, until the LED is off, release the button, LED light up again, press the button again, When hearing a beep, restore factory settings successfully.
Note: If this sensor is reset, the information of Z-Wave network in the sensor will be deleted. The sensor will be itself restored to factory default settings. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smoke Alarm Sensor from siterwell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smoke Alarm Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.