The following is an overview of the user manual for the Z-Wave product SAMSUNG Connect Home (ET-WV520)from Samsung Electronics, Co., Ltd.. To view other Z-Wave products and manuals from SmartThings follow that link.
Overview
Security
As a Z-Wave Plus certified product, SAMSUNG Connect Home supports Z-Wave S2 security. The following security modes are directly supported:
Features
SmartThings describes SAMSUNG Connect Home as having the following features:
- Z-Wave Scene Type
- Color
- Communications Connections
- Controller Supports Multiple Z-Wave Interfaces
- Communications Protocol
- Controller Supports Multiple Networks
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
In the app's, open the My Home Button, and then tapping “+ Add a Thing”. After tapping, the screen says ""Searching"" to indicate that inclusion mode is active.
In the app's ""My Home - Things"" tab, tap the name of the device to show the device details. Then, open the menu in the upper right and tap 'gear icon' and tapping the 'remove' button.
Alternatively, The hub is put in network wide inclusion mode by tapping the more menu button, at the upper left of the Dashboard and then tapping ‘gear icon ’ in the side menu. After tapping the gear to the right upper of the Location name, scrolling down to the Hubs section and tapping [Your hub] > Z-Wave Utilities > General Device Exclusion > Remove
Learn mode is activated from the app by going to the 'more menu' button, at the upper left of the Dashboard and then tapping ‘gear icon’ in the side menu. After tapping the gear to the right upper of the Location name, scrolling down to the Hubs section and tapping [Your hub] > Z-Wave Utilities > Join or Leave Existing Z-Wave Network
Factory reset SAMSUNG Connect Home
The only way to factory reset the Z-Wave module from the mobile app is to delete the hub’s location. From the side menu, tap the gear to the right of the Location name to access the settings. Make sure the hub is listed as “Active” when you delete the location.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual SAMSUNG Connect Home from Samsung Electronics, Co., Ltd. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have SAMSUNG Connect Home and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.