ONU Integrated Service Router (NSD-G1000T) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product ONU Integrated Service Router (NSD-G1000T)from Sony Network Communications. To view other Z-Wave products and manuals from SONY follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


ONU Integrated Service Router
SKU Code
The current product is a home gateway device. IoT devices such as sensors are connected and can be controlled with this
device. This device supports various interfaces for the functionalities of Wireless LAN, Bluetooth, Z-Wave and Mobile
The device can collect sensing data from various Z-Wave sensor devices, and uploading of the data to a cloud server by
wired LAN communication is available.
The ONU Integrated Service Router has the following general features:
- 4 LAN Ports
- Wireless LAN client
- Z-Wave communication
- Bluetooth communication
Version #
HW: 1 FW: 6.02:02.81 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, ONU Integrated Service Router supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Access Control
  • S2 Authenticated
  • S2 Unauthenticated


SONY describes ONU Integrated Service Router as having the following features:

  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: As the camera starts, hold it over the QR code.
Register or Unregister the DSK when you correctly hold the camera over a QR code on product label. (Full DSK is printed on a gift box)

QR code is on a product label in a PON Cover.
Since the QR code is written on the inside of the PON cover, it is protected from the wonders of rubbing and dirt.

To remove a device from the Z-Wave network, press the “Exclusion” button in the Android Controller Application.

Factory reset ONU Integrated Service Router

Press “RESET” in the Factory Default Reset dialog. This will reset the Z- Wave chip, and the gateway will show “DEVICE RESET LOCALLY NOTIFICATION” after the restart.

To add a device to the Z-Wave network, press the “Inclusion” button in the Android Controller Application.

Please note that this is a user manual ONU Integrated Service Router from Sony Network Communications is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have ONU Integrated Service Router and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.